Adding a lateral automatically puts a cleanout where you start drawing (you can swap out or delete the cleanout). Here's how you add the lateral:

1. Open the Sewer tab by clicking on the Sewer icon

2. Select Lateral

3. Click on the access point.

4. If the lateral isn’t straight, click on the first points where it curves. Then click on the next point, until you reach the lateral’s tap into the mainline. Double click on the end point of the lateral.

5. You can change some information about the lateral from the next page, including length, what that access and end point is, distance from mainline access, and flow direction. Hit Save in the lower right.

Nice! You now have a lateral on the map.

If you run into any issues or have any questions, please reach out to us at support@unearthlabs.com

Did this answer your question?