You take the same steps to add obstructions, defects, and other issues to the pipes you’re inspecting. Here are those steps:

1. For Sanitary Sewer obstructions, select Sewer. If you’re adding a Stormwater obstruction, click on the Storm tab.

2. Scroll down to see Obstructions, Pipe Defects, or Miscellaneous issues. Select the issue you want to add to the map.

3. Click on the spot on the pipe or the map where you’re finding the issue. If the issue is along a length of pipe and not only in one point, then click where the issue starts and drag to where the issue ends.

There’s no need to hit any Save button - the issue has been added to the map already.

If you run into any issues or have any questions, please reach out to us at

Did this answer your question?